Bulova: Marine Star Diver 200m

Bulova_Marine_Star_Diver_Front_London_2014

Nicht in Basel gezeigt, dafür jetzt auf der Website zu finden: Bulova hat innerhalb der Marine Star Kollektion ein Tauchermodell mit automatischem Aufzug angefügt.

Witzigerweise gibt’s auf der selben Website keinerlei Info zu Grösse und Innenleben, ein schneller Blick auf ein paar Online-Händler offenbart aber 47 mm beim Durchmesser und 13 mm bei der Bauhöhe, der verschraubte Gehäuseboden kommt ohne jegliche Verzierung. Die Wasserdichtheit liegt gemäss Zifferblatt bei 200 Meter, beim Glas täte ich jetzt eher auf Mineral tippen und beim Werk etwas aus der Richtung von Citizen/Miyota vermuten.

Eher fraglich ist die Platzierung des Datums, und die verschraubte Krone hat viel Luft bis zum Kronenschutz. Die auf dem Bild als poliert wirkende Ausführung steht zudem etwas im Widerspruch zum satinierten Gehäuse. Die Funktion der Schrauben auf dem Drehring ist ebenfalls eher unklar.

Mindestens drei Varianten gibt’s davon: Die hier abgebildete Ref. 98B209 mit schwarzem Blatt und Drehring, die 98B207 mit orangem Drehring und Band sowie die 98B208 mit silberfarbenem Zifferblatt und blauem Inlay/Band. Preis liegt bei allen Modellen bei 475 Dollar. © Bild: Bulova

2 Kommentare

  1. I just purchased the black 98b209. So far it has been a fine watch.I believe there has been some confusion on which way to rotate if you keep it on a winder. I believe this has Miyota 8215 movement, there is an arrow on the rotor pointing CCW which means if you are looking at the front of the watch the watch should rotate CCW, hence, rotor, from facing front of watch CW. I found this out when the watch wasn’t staying wound because on the FAQ page it says to set winder CW. This movement does not hack although it is easy to set the time and watch will not wind with crown. The lume is very bright and lume stays bright and readable for a long time. This is my first auto and I use a winder because I have multiple watches. If you will have just this watch you probably don’t need a winder. If it goes past the power reserve just a shake will get it running. It does have the „Miyota Stutter“ so if you see the second hand jumping a bit between 2 o’clock and 6 o’clock it is normal. If you jar the watch the second hand will pause then start again which is normal. I have only had this watch for about a month so far so good although it hasn’t been submerged so I can’t tell you about water. It does have a screw down crown.

  2. I did comment on Bulova 98b209 if anyone wants to comment or have questions about my post feel free. I actually have my winder turning CW for 20 minutes then CCW for 20 minutes then it pauses for 30 minutes then repeats but I am sure the watch from looking at the front of it needs to rotate CCW. I have read on many posts the confusion. Remember, looking at movement from backside the arrow pointing CCW so if you turn the watch over and face it the watch itself should rotate CCW and from facing front of watch the rotor turning CW. Just a little confusing since the rotor is unidirectional.

Kommentar verfassen

Diese Website verwendet Akismet, um Spam zu reduzieren. Erfahre mehr darüber, wie deine Kommentardaten verarbeitet werden.

%d Bloggern gefällt das: